Picture # 1
Here is our Chrysler 300 in need of a GrillCraft MX Series mesh front
grille.
|
Picture # 2
Remove the plastic clips located on the top side of the bumper cover.
|
Picture # 3
Remove bolts located on the front bottom side of the bumper cover.
|
Picture # 4
Remove the plastic clips that hold front section of the splash shield to
the bumper cover.
|
Picture # 5
Remove the bolt located in the fender well area behind the splash shield
this bolt is is in the vertical position.
|
Picture # 6
Remove the washer fluid hose and drain the washer fluid.
|
Picture # 7
Unclip the bumper lamp wire harness.
|
Picture # 8
Pull the bumper cover forward in order to unlcip the bumper.
|
Picture # 9
On the backside of the bumper cover remove the clip that retains the
bumper foam filler (using a small flat screwdriver will work to remove
this clip)
|
Picture # 10
Removing the backside bumper foam filler.
|
Picture # 11
Remove the screws that hold the original grille in place.
|
Picture # 12
Place the GrillCraft Mesh grille into the bumper and mark the mounting tab
hole locations.
|
Picture # 13
Drill 3/16 inch hole for the mounting screws.
|
Picture # 14
On lite colored vehicles we recommend painting the area behind the grille
with fast drying flat black spray paint.
|
Picture # 15
Fasten the grille in place with the supplied hardware.
|
Picture # 16
OPTIONAL Use Chrysler Part# 04805988-AA (chrysler 300 trunk emblem
wings) If you desire the Chrysler Badge on the grille. Remove prongs from
emblem.
|
Picture # 17
The factory emblem has a adhesive back peel and stick to the front of the
grille.
|
Picture # 18
Using the supplied epoxy kit apply the epoxy to the back side of the
emblem.
|
Picture # 19
Wow What a Difference !!!!!!!!!!
|
Picture # 20
Looking good with GrillCraft
|
Picture # 21
Bling Bling !!!!!!!!!!!
|
Picture # 22
GrillCraft Grilles are the best.
|
Picture # 23
The GrillCraft Chrome Mx Series Mesh Grille.
|
Picture # 24
Fits like a glove!!!
|
